ROHN 9H50 34' Telescoping Mast - Antenna Push Up Pole - Ships FedEx/UPS Ground

Description

ROHN 9H50 TELESCOPING MAST
UPS / FedEx Ground Shippable
Genuine ROHN Product
Pre-galvanized for corrosion protection
Comes assembled with hardware
Top rings are adjustable based on antenna mounting
Weighs 34 lbs
Bottom: 2-1/4" OD
Top: 1-1/4" OD
Shipping Length: 99"
410" (34') Actual Extended Pipe Length - Assembled Height will be around 30'
Sections are as follows:
Top: 1.25" OD x 16 Gauge
1.50" OD x 18 Gauge
1.75" OD x 18 Gauge
2.00" OD x 18 Gauge
Bottom: 2.25" OD x 18 Gauge
NOTE: GUYS, GUY HARDWARE, ANCHORS, AND BASE MOUNT ARE NOT INCLUDED.
ROHN does not recommended telescoping masts for commercial, CB or beam antenna installations.
The antenna top load should not exceed an effective projected area of 2 sq. ft.
Pictured guy layouts are for a typical installation - individual installation requirements may vary.
Erecting the Telescoping Mast is made by simply connecting guys and brackets to the attached unique heavy duty rolled edge guy rings and clamps, extend the sections, insert the locking cotter pins, rotating the tubes to a locked position, and tightening the clamps.
The unique ROHN Telescoping Mast design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common masts. This exclusive design also prevents the sections from accidentally pulling apart and allows disassembly by pulling each section out through the lower end.
Each section extends deeper in to the lower tubes than most other Telescoping Mast designs, adding still further to the stability of the structure. Due to overlapping extended masts will be shorter.
Illinois purchases are subject to 6.5% sales tax